Pressure and Flow Calibration Software

Fluke Corporation, DH Instruments Division   Fluke Corporation
  DH Instruments Division
  Phone: 602.431.9100
  Fax: 602.431.9559

Visit other Fluke companies for calibration equipment and services in electrical, power, pressure, flow, RF, and more.

www.fluke.com

Embedded [pressure ] [flow] [USAF]

Pressure

TITLE	VER	USE WITH
PG7000™	1.05f	PG7102, PG7302 or PG7601
Updates Include:
1.05f ADD: Support for auto-float targets < 3 psia VAC. FIX: Allow recovery from autofloat overshoots that could stop the autofloat execution. 1.05d CHG: Corrected calculation of piston fall rate. 1.05c ADD: Increase # of PCs from 3 to 18. CHG: Change max # of masses in a mass group from 10 to 99. ADD: Cal & temp coefficient fields & remote command. ADD: Application of the temp coefficient. CHG: Gauge PG label from 7202 to 7102. 1.05b CHG: The opening credits to show correct model (PG7601, PG7102 or PG7302). ADD: New motor control power speed tables for new style board. Eliminate the DIP switch setting for motor type. Use this switch to ID new style boards. ADD: A check for the serial # and query the user if it has been set yet. ADD: Factory reset entry screen & menu function for discrete facory resets (DIAG only). FIX: AIR medium z calculation error. Reset the AutoFloat factory settings when the PG is initialized. CHG: the platter rotation ready criteria from 45 to 30 rpm for the PGG & PGO. ADD: TEST selection to the DIAG menu to execute the COMx & IEEE production tests.

Download File:

FREE Download
pg1_05f.bin (176 kb)

Instructions:

Download the file.

Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC.

Use a null modem cable to COM2 port of PG7000 Piston Gauge.

Use a standard RS232 cable to COM1 port of PPC, PPC, RPM and molbox.

The updating of embedded software should only be performed after given specific instructions to do so from a DHI Authorized Service Center.

If the update isn't performed properly, your product will be inoperable until it is.