Pressure and Flow Calibration Software

Fluke Corporation, DH Instruments Division   Fluke Corporation
  DH Instruments Division
  Phone: 602.431.9100
  Fax: 602.431.9559

Visit other Fluke companies for calibration equipment and services in electrical, power, pressure, flow, RF, and more.

www.fluke.com

Embedded [pressure ] [flow] [ USAF]

Pressure

TITLE	VER	USE WITH
RPM4-AD™	1.00e	RPM4-AD
Updates Include:
Ver 1.00e (2008 Dec 22) FIX: Advance Q-RPT compensation not being applied to the Lo Q-RPT. Lo Q-RPT should be recalibrated when RPM4-AD is upgraded to this version of embedded software.
Ver 1.00d (2007 Dec 14) FIX: AutoZ on the Lo RPT was always turned OFF when the Hi RPT was active. When AutoZ on the Lo RPT is ON, it now always stays on regardless of active RPT. FIX: Certain remote commands could accidentally cause the HL RPT to be disactivated and could turn off absolute and negative gauge measurement modes. Those remote commands have been repaird.
Ver 1.00c (2007 Jan 15) ADD: Support of the RPM4-AD A350K/A160K (fixed wing) model.
Ver 1.00b (2006 Oct 24) FIX: Q-RPT range configuration would be reset when upgrading from v1.00 to 1.00a requiring the Q-RPT ranges to be redefined.
Ver 1.00a (2006 Sep 28) ADD: Keep the Lo Q-RPT display resolution same as the Hi or HL Q-RPT so that resolution of Lo Q-RPT can be set in A160K/A160K version. ADD: Add capability to AutoZ with altitude unit active.
Ver 1.00 (2005 Nov 21) Inital release of software for new RPM4-AD Reference Pressure Monitor, Air Data Version.

Download File:

FREE Download
100e.bin (277 kb)

Instructions:

Download the file.

Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC.

Use a null modem cable to COM2 port of PG7000 Piston Gauge.

Use a standard RS232 cable to COM1 port of PPC, PPC, RPM and molbox.

If your product has
an model number ending in “-AF”,
it requires specific
“-AF” embedded software (see [USAF])

The updating of embedded software should only be performed after given specific instructions to do so from a DHI Authorized Service Center.

If the update isn't performed properly, your product will be inoperable until it is.